Initial Configuration OLT - Optronics
Note
The following steps are for a new Optronics OLT or one that has been reset to its factory settings.
To have a clearer understanding of how the OLT connection is structured when configuring, you can refer to the following diagram on how to make the physical connection.
Steps to Set Up New OLT
Access Data
Username: optronics
Password: optronics
Default IP: 192.168.8.100
Password: optronics
Default IP: 192.168.8.100
1 We must verify that we have internet access
2 We must have our VLAN added, Administration LAN, and Customer Segment LAN. For more information, you can read the Configuration Manual for MikroTik RouterBoard for Optronics OLT (Coming Soon)
3 We must test the connection with the OLT with the default IP assigned
4 Connect our computer to the router's network and ping from our terminal
5 Access the OLT's graphical interface
6 Configure the new OLT IP
New IP
In this step, we will change the OLT Default IP to one from our Administration LAN, which for this example must be in the range 192.168.20.1/24, for this case we will assign the IP 192.168.20.115.
We must log in again, but with the new IP
Next Step
Now you can add it to AdminOLT, you can follow the steps in the manual Add Optronics OLT
April 12, 2024, 3:32 p.m. - Visitas: 5137