Configuration on MikroTik RouterBoard for OLT Vsol Single PON - adminolt.com

Configuration on MikroTik RouterBoard for OLT Vsol Single PON

Note

The following steps are to show an example of how the basic structure of a fiber network should be. To have a clearer understanding of how the OLT connection is structured when performing the configuration, you can refer to the following diagram.

Router with Internet Output

Let's start assuming that the equipment already has the initial configurations to have Internet output, so it is required to verify that there is an Internet connection.

Connection through Ethernet port.

Bridge Creation

We are going to create a bridge to assign an IP from the default administration network of the OLT and also be able to assign an IP when we change the default network.

1 Go to the Bridge section in the RouterBoard menu to create the bridge1 interface and thus be able to group the ports that will be working on the OLT network.

 

2 Assign the two ports connecting to the OLT to bridge1.

Vlan Creation for Hosts

1 Go to the interface configurations and to the Vlan section, where you will create a vlan named vlan300 with ID 300, which will be where the subnet for hosts will be created.

IP Addressing

1 In IP Address, assign the IP to each interface as shown in the following images, which are based on the topology shown at the beginning of the manual.

2 IP addressing for the default Administration network. This is the network that comes in new Vsol OLTs or those that have been reset to default values. This IP will only serve us to connect to the equipment for the first time, as later in the OLT configuration we will change it to our administration network.

3 IP addressing for the administration network. This will be the IP we use to work on our new administration network.

4 LAN IP addressing for OLT Vsol. This address will be the Gateway for the LAN network for Hosts (ONUs) of Vlan300, which will serve us to give addressing statically, through DHCP, or through a PPPoE server.

Next Step

Once completed, you can continue with the next step Initial Configuration New OLT - Vsol Single PON

April 12, 2024, 3:32 p.m. - Visitas: 4739